Pemko 90062 Nylon Brush Gasket w/ 90 Degree Aluminum Retainer & 5/8" Brush

Brush Door Sweeps are designed to seal the gap between the bottom of the door and the top of the threshold or floor surface. They are usually supplied with a flat flange. The flat flange provides the best contact between the brush and the threshold or floor surface.

• Design permits use as a concealed seal for many applications.
• Slotted holes for adjustment.
• All clear anodized brush products are supplied with gray brush (available with black brush upon request). Other finishes supplied with black brush.
• All brush seals consist of densely compressed nylon filaments encased in high quality aluminum retainers. These products are ideally suited for hollow metal and wood door (in-door sweep, jamb/header gasketing, and split astragal) applications. Also use our brush weatherstripping products on overhead doors, sectional doors, sliding doors, and automatic doors.
• All brush seals greatly reduce the infiltration of light, air, wind, rain, and snow; prevent heat loss; control the penetration of smoke and fumes.
• The dense nylon filaments conform to the contours of every sealing surface, providing a superior seal with extremely low closing force.
• Brush remains flexible down to -40°F and has a melting point above 400°F.
• UV stabilized, dependable, long-lasting, cost-effective.
• Nylon brush insert is designated by a "NB" following the finish code.
• All brush seals come with #6 × 5/8" stainless steel sheet metal screws.
• Punched with slotted holes for adjustment (except 35° angle types which are drilled with 1/8" hole).