Rixson 275065-PKG Model 27 Arm Shims
$39.05
$65.09
40% Off
- Model:
-
275065-PKGItem normally ships out within 7-10 Weeks (excluding transit time).Specific options may or may not increase shipping time. For any reason, if there is a delay in shipping time we will notify you. Feel free to contact us if you have any concerns.
Request for Quote
Details: Rixson 275065-PKG Model 27 Arm Shims
Check the clearance between bottom of the door and the floor. The door should not be dragging on the floor. If the door needs to be raised to provide clearance, shims can be inserted at the bottom to accomplish this.
For CENTER HUNG applications, shims must be inserted between the ARM PLATE "H" and the bottom of the cutout. The door needs to be removed for shims to be added. See installation instructions.
For most OFFSET applications, 1/16" shims can be added without removing the door. Remember that the weight of the door must bear on the bottom arm, not on the intermediate pivot (if used).
Features
- Loosen the ARM LOCKING SCREW on the offset bottom arm.
- Raise the door by lifting the bottom of the door with a crowbar (or by removing the cover cap on the intermediate pivot and turning the pivot pin screw clockwise).
- While the door is held in the raised position, insert the required quantity of shims (P/N 275065) directly beneath the bottom arm.
- Relieve the tension on the crowbar (or intermediate pivot) and allow the bottom arm to carry the entire weight of the door.
- Re-tighten the ARM LOCKING SCREW
Applications
- Public Buildings & Facilities
- Commercial & Industrial Buildings
- Government & Military Facilities
- Retail & Strip Malls
- Multifamily & Mixed-Use
Downloads
Privacy Policy
Loading...